Details
The V100 Modular Mixer Power Amplifier 100W by Bogen from Power Vector series is designed to work with both high impedance and low impedance speaker systems (70V/25V, 4ohm / 8ohm). Includes eight module bays for plug-in input modules and allows up to four levels of priority between modules.
Two module bays are capable of accepting plug-in signal-processing output modules. Each module is controlled by an independent volume control with an associated signal/clip LED for signal status. An 11-segment LED output meter monitors output signal level.
SPECIFICATIONS
- Power Output (RMS):
Rated:100W
Typical @ 1 kHz:*140W - Frequency Response
Transformer: 45 Hz to 20 kHz; +0/-2 dB
Direct: 20 Hz to 20 kHz; +0/-1 dB - Distortion
Transformer: < 0.5%**
Direct: < 0.1%** (.05 typical @ 1 kHz) - Signal-to-Noise†
Fundamental: -94 dB
With SAX1R Module: -70 dB
With MIC1S Module: -60 dB
With TEL1S Module: -70 dB - Tone Controls
Bass Frequency: @100 Hz (+/- 10 dB minimum)
Treble Frequency: @10 kHz (+/- 10 dB minimum)
Low Cut Frequency: @125 Hz (-6 dB/octave) - Sensitivity 0.4V (at backplane connector)
- Output Regulation: 2 dB or better, no load to full load
- Output Impedance
Transformer-Coupled: 70V, 25V, 8 ohms (bal or unbal)
Direct Coupled: 4 ohms (minimum) - Thermal Emissions (BTU/hr.): 495.2
- Inserts
Insert "OUT" Level: 1VRMS (@FRP)
Insert "OUT" Impedance: 50 ohms maximum
Insert "IN" Sensitivity: 1VRMS
Insert "IN" Impedance: 10k ohms minimum - Bridging In/Out
Bus Level: 250 mVRMS (@FRP)
Bus Impedance: 10k ohms maximum - Pre-EQ Output
Output Level: 4VRMS (@FRP)
Output Impedance: 50 ohms maximum - AC Power Receptacle: 500 watts maximum power, unswitched
- AC Voltage: 120V AC, 60 Hz
- AC Current: 2.0A
- Product Weight (lb.): 28
- Dimensions: 17-1/4" W x 3-7/8" H x 14-3/4" D (all models)
* Typical, @1 kHz/0.1% THD/4-ohm direct ** THD+N, Maximum, Full bandwidth @ FRP † Referenced to FRP output level, 20 Hz to 20 kHz bandwidth limited
Additional Information
Promotional Message | No |
---|---|
SKU | V100 |
Mount Type | No |