Details
The Bogen WV250 Power Amplifier 250W Wall Mount is designed to work with both high impedance speakers systems and low impedance speaker systems. Each model includes eight module bays for plug-in input modules and allows for up to four levels of priority between modules.
Two module bays are capable of accepting signal processing plug-in output modules. Each module is controlled by an independent volume control with an associated signal/clip LED for signal status. An 11-segment LEDāoutput meter monitors output signal level. Each model includes a motorized master volume control that can be controlled using a remote volume control panel (RVCP, sold separately).
SPECIFICATIONS
- Power Output (RMS)
250W (340W Typical, @1 kHz/0.1%/4W) - Frequency Response
Transformer: 45 Hz to 20 kHz; 0/-2 dB @ FRP
Direct: 20 Hz to 20 kHz; 0/-1 dB @ FRP - Distortion
Transformer: 0.5% THD+N, Maximum, Full-rated bandwidth @ FRP
Direct: 0.1% THD+N, Maximum, - Full-rated bandwidth @ FRP
Signal-to-Noise
Fundamental: -94 dB*
With Aux Module: -70 dB*
With Mic Module: -60 dB*
With Tel Module: -70 dB* - Tone Controls
Bass Frequency: 100 Hz (+/- 10 dB minimum)
Treble Frequency: 10 kHz (+/- 10 dB minimum)
Low Cut Frequency: 125 Hz @ -6 dB/octave - Sensitivity: 0.4V (at backplane connector)
- Output Regulation: 2 dB or better, no load to full load
- Output Impedance
Transformer-Coupled: 70V, 25V, 8 ohms; balanced or unbalanced
Direct Coupled: 4 ohms unbalanced - Tape Out
Output Level: 4 VRMS @ FRP
Output Impedance: 50 ohms maximum - Overload Protection: Electronic overload protection (auto reset)
- Thermal Protection: Thermistor attached to heat sink
- Line Fusing: Resettable circuit breaker
- Cooling: Thermally controlled 3-speed fan
- Power Consumption:
5.5A @ 120V AC, 60 Hz - Thermal Emissions:
911.9 BTU/hr. - Dimensions:
14-1/8" W x 21" H - Product Weight:
28 lb.
Additional Information
Promotional Message | No |
---|---|
SKU | WV250 |
Mount Type | No |